The Door Bull Brass Pool Cover Anchors 10-Pack for Concrete & Paver Decks — Corrosion-Resistant with Matching Screws

The Door Bull Brass Pool Cover Anchors are a 10-pack of corrosion-resistant brass anchors and matching head screws designed to secure safety pool covers into concrete or paver decks.

These anchors are built to hold safety covers firmly in place in windy conditions while resisting rust and corrosion thanks to gold-colored bronze brass construction. Each kit includes ten anchors and ten head screws sized to fit a 3/4" drilled hole and a 1-5/8" anchor length, making them compatible with most major pool cover brands. The set is intended for in-ground installation into concrete or paver decking and is manufactured with precision equipment to meet high quality standards.

How do these anchors keep a pool cover secure in bad weather?

Heavy-duty brass construction and the included head screws make a strong, tamper-resistant connection between the safety cover and the deck. When correctly installed into a clean 3/4" hole, the anchors resist pull-out and maintain cover tension during wind events without corroding.

• Solid bronze brass resists rust and electrochemical wear
• Sized for a tight fit in a 3/4" drilled hole
• Includes matching head screws for a complete fastening system
• 1-5/8" anchor length suitable for typical deck thicknesses

Will these anchors work with my concrete or paver deck?

Yes — the anchors are designed for both poured concrete and paver installations. The geometry and dimensions are chosen to secure into hardened concrete or compacted paver bases without needing specialty parts.

• Fits all major pool cover brand fittings that use a 3/4" anchor hole
• Works in both poured concrete and interlocking paver surfaces
• Drill a 3/4" hole and lightly tap anchors into place for best retention
• Head screws thread back into the anchor for a flush, finished look

How straightforward is installation for a DIY project?

Installation is intended to be quick for a homeowner with basic tools: drill, hammer, and screwdriver. Remove any old anchors, drill a clean 3/4" hole, clear debris, seat the anchor with a gentle tap and reinstall the head screw — no extra parts required.

• Includes 10 anchors and 10 head screws — no additional purchases needed
• Simple drill-and-tap installation for typical DIY skill levels
• Replaces worn anchors without altering existing cover hardware
• Manufactured to consistent tolerances for repeatable installs

What maintenance should I expect over time?

Bronze brass is low-maintenance compared with plated or stainless options; occasional rinsing and inspection are usually sufficient. Check fasteners seasonally and tighten head screws if needed to keep the cover seated and safe.

• Minimal corrosion means less frequent replacement
• Rinse with fresh water after prolonged exposure to pool chemicals or salt
• Inspect and retighten head screws once or twice per season
• Replace individual anchors as needed — sold as a 10-pack for multiple points

Who is this for: The Door Bull Brass Pool Cover Anchors suit homeowners, pool maintenance professionals, and installers who want a durable, ready-to-install anchor solution for securing safety covers to concrete or paver decks. If you need corrosion-resistant hardware that fits common cover systems and keeps a cover taut through wind and seasonal use, this 10-pack provides all necessary parts with straightforward installation and long-lasting performance.