Menkxi Dual Split Pool Hose Plunger Valve Kit — 1.5 x 59 in Hoses, 2-in-1 Split Valve for Above-Ground Pumps, Leak-Resistant Seal

The Menkxi Dual Split Swimming Pool Hose Plunger Valve is a two-in-one split valve and hose kit that lets you control two outlets from a single connection for above-ground pool filter pumps.

Designed for above-ground pools, this green Menkxi kit includes one split plunger valve and three 59-inch hoses. The assembly works with common 1.25" and 1.5" hose sizes, uses a threaded collar and elastic sealing ring to cut leaks, and simplifies routing or vacuuming tasks without buying separate adapters. Built from durable plastic components, the valve routes flow between two outlets while one plunger handle opens or closes the lower outlet.

How does the dual split plunger valve simplify pool pump connections?

The split valve combines two outlet controls into the footprint of one connector, reducing the number of separate valves you need. It lets you split suction or return flow into two lines while keeping one common inlet, which is useful when adding a vacuum line or directing flow between tools.

• Two outlets controlled from a single inlet for fewer fittings.
• Top plunger opens or closes the lower outlet without disconnecting hoses.
• Compatible with 1.25" and 1.5" hoses—no extra adapters required.
• Includes threaded collar and elastic ring for easier leak prevention.

Will this kit fit my above-ground pool filter pump?

It fits most common above-ground pool filter systems that accept 1.25" or 1.5" hoses, provided the connector diameters match. For best results use the included hoses or ensure your existing hose ends have matching threaded collars and clamps to prevent leaks.

• Designed for 1.25" and 1.5" standard pool hoses.
• Works with many aftermarket and factory pumps—check connector diameter first.
• Recommended to use matched hoses with threaded rings for a secure fit.
• Comes with three 59-inch hoses to replace worn lines or extend reach.

How do I install and operate the Menkxi split hose plunger valve?

Installation is straightforward: slide the threaded collar to the end, position the hose over the connector, then tighten clamps to secure. The plunger at the top acts only on the lower outlet—left and right outlets remain permanently connected—so operate the plunger to allow or stop flow through the lower port.

• Pull the threaded collar fully to the bottom before sliding the hose on.
• Attach hose, tighten clamps, then slide collar forward and secure.
• Use the top plunger to open/close the lower outlet only; left/right remain linked.
• Check seals and clamps to avoid leaks during first run and after pressure change.

What are the durability and maintenance considerations?

The valve body is molded from robust plastic and uses an elastic rubber ring where the seal is needed to limit leaks. Routine checks of clamps, the rubber ring, and hose condition will extend life—replace the included hoses when they show cracking or excess wear.

• Durable plastic construction resists common pool chemicals and handling.
• Elastic sealing ring helps prevent water escape at the joint.
• Inspect clamps and hose ends seasonally for secure connections.
• Replace hoses if they become brittle, cracked, or excessively faded.

Who is this for: Pool owners who need a compact, cost-effective way to split or control suction/return lines on above-ground pools and smaller filtration systems. It’s a practical choice for hobbyists who perform routine vacuuming, temporary rerouting, or want to add accessories without installing multiple valves. If your system uses 1.25" or 1.5" hoses and you prefer a single, simple control point for two outlets, this Menkxi kit offers an economical, easy-to-install solution.