Htanch Replacement Burner Electrodes for American Outdoor Grill — 3-Pack OEM-Compatible Sparks for 24/30/36-inch Models

Htanch EB4B01 is a 3-pack of replacement burner electrodes designed to restore reliable ignition on compatible American Outdoor Grill gas grills.

When a grill's piezo or electronic ignition fails, the electrode that creates the spark is often the culprit. The Htanch EB4B01 set provides three OEM-compatible electrodes sized and shaped to match a range of American Outdoor Grill (AOG) models, so you can swap worn or corroded parts quickly and get back to even, dependable lighting without replacing the entire burner assembly.

Which grill models will these electrodes fit?

The EB4B01 electrodes are made to fit several AOG burners across 24-, 30- and 36-inch product lines, plus certain Dyna-Glo units that share the same parts family. Confirm your grill model number before purchasing to ensure full compatibility.

• Fits AOG 24NB, 24NG, 24NP, 24PC models
• Compatible with AOG 30NB and 30PC models
• Also fits AOG 36NB and 36PC and Dyna-Glo DCP480CSP where applicable

How easy is installation and what tools do I need?

Installation is straightforward for anyone comfortable working with basic grill maintenance. You’ll typically remove a few screws, disconnect the old electrode wire, and install the new electrode in the same position—no special soldering required.

• Basic screwdriver set and pliers recommended
• No specialty tools or advanced wiring skills needed
• Typical swap takes 10–20 minutes per electrode

Will these electrodes restore reliable ignition and durability?

Replacing a corroded or cracked electrode usually resolves intermittent or failed ignition events because the electrode is the spark source. These Htanch replacements are manufactured to meet the original part geometry so they align with the burner and igniter lead for consistent sparking.

• Manufactured for OEM-compatible fit and alignment
• Resists common grill conditions like heat exposure and light corrosion
• Three-pack provides spares for multi-burner grills or future maintenance

What troubleshooting steps should I try if ignition still fails?

If ignition problems persist after replacing the electrode, check the igniter wire connections, electrode gap, and cleanliness of the burner ports. Environmental wear or wiring damage outside the electrode can prevent spark transmission even with a new part installed.

• Inspect and clean burner ports and electrode tip for soot or debris
• Verify the electrode-to-burner gap and secure wiring connections
• Test the igniter module or battery if your grill uses a battery-powered spark

Who is this for: Grill owners who use American Outdoor Grill or compatible Dyna-Glo models and need a simple, cost-effective way to replace worn or damaged ignition electrodes. The Htanch EB4B01 3-pack is ideal for households with multi-burner grills, repair technicians keeping stock parts on hand, and anyone wanting to avoid downtime caused by ignition failure. Always confirm your exact model number against the listed compatible units before ordering to ensure proper fit.