Hayward Auto-Skim Replacement Gaskets for Wide-Mouth Inground Skimmers — Set of 2, OEM Fit

Hayward SPX1085DPAK2 is a genuine OEM set of two replacement gaskets made to restore proper sealing and fit for Hayward Auto-Skim wide-mouth inground automatic skimmers.

When an automatic skimmer begins to leak, whistling or fails to seat properly, the gasket is often the simple part that fixes it. The SPX1085DPAK2 gasket set is manufactured by Hayward to match the geometry of the Auto-Skim series (including models SP1085OM and SP10852OM), so installation is straightforward and the parts fit as intended. This listing contains two gaskets — enough to service a single skimmer or keep a spare on hand for quick maintenance.

How will these replacement gaskets stop common skimmer problems?

Worn or distorted gaskets let air and water bypass the intended seals, which can cause poor skimmer performance, surface agitation, or minor leaks. Installing fresh OEM gaskets restores the original seal between the skimmer throat and the lid or collector assembly, improving suction and keeping debris flowing into the basket as designed.

• Restores a tight seal to prevent air from entering the skimmer line
• Eliminates whistling or gurgling caused by gaps or cracks
• Helps maintain consistent skimmer suction and debris capture
• Two gaskets included — replace both sides or keep a spare

What models and skimmer types are these gaskets compatible with?

These gaskets are made to fit Hayward Auto-Skim series wide-mouth inground automatic skimmers. They are compatible with specific Auto-Skim model numbers such as SP1085OM and SP10852OM and match Hayward’s original part dimensions to ensure a correct fit.

• Designed for Hayward Auto-Skim series automatic wide-mouth skimmers
• Explicit fit for models SP1085OM and SP10852OM
• OEM part manufactured to Hayward tolerances and materials
• Sold as a pair to service one skimmer or keep an extra gasket

How difficult is installation and what tools are needed?

Replacing these gaskets is usually a straightforward, low-skill job that most pool owners can complete with basic tools. Typically you will remove the skimmer lid or collector, lift out the old gasket, clean the seating surfaces, and press the new gasket into place. No adhesives are normally required unless the skimmer manufacturer specifies otherwise.

• Basic hand tools recommended: screwdriver or nut driver for lid fasteners
• Clean cloth or mild cleaner to remove old residue from seating surfaces
• Hands-on fit — press gasket into the groove until fully seated
• Check operation after reassembly and prime the pump if necessary

What should I expect in terms of durability and care?

Hayward OEM gaskets are manufactured for pool environments and resist typical pool chemicals and sunlight exposure within normal operating ranges. Expect them to last several seasons depending on chemical balance, sunlight exposure, and mechanical wear. Inspect gaskets annually and replace them when they show signs of cracks, flattening, or loss of elasticity.

• Engineered for pool chemical resistance and outdoor use
• Inspect yearly; replace if deformed, cracked, or hard/brittle
• Storing a spare gasket helps minimize downtime during repairs
• Replace as part of routine skimmer maintenance to preserve performance

Who is this for? The Hayward SPX1085DPAK2 gasket set is intended for pool owners, maintenance professionals, and service technicians who maintain Hayward Auto-Skim wide-mouth inground skimmers (such as SP1085OM and SP10852OM) and want genuine OEM parts for reliable fit and function. If you own or service a Hayward Auto-Skim skimmer and are experiencing leaks, loss of suction, or degraded skimmer performance, this two-piece gasket set provides a quick, manufacturer-compatible solution.