Greenworks 10" Pole Saw Bar and Chain Combo — 10" Guide Bar, 1/4" Pitch .050" Gauge, 58 Links Genuine OEM

The Greenworks 10" pole saw bar and chain combo is a genuine replacement set engineered to restore cutting performance on compatible Greenworks pole saws.

If your pole saw's chain has dulled or the bar shows wear, replacing both parts at once brings the cutting system back to original alignment, tension behavior, and safety. This package includes a 10-inch guide bar and a matching low-profile chain with a 1/4" pitch, .050" gauge, and 58 drive links — the exact specification Greenworks lists for many of its telescoping pole saw models. Swap in this genuine OEM combo to avoid fitment issues and maintain designed cutting geometry.

Will this bar and chain fit my Greenworks pole saw?

This replacement set is designed for Greenworks pole saws that specify a 10" bar, 1/4" pitch, .050" gauge, and 58 drive links. Confirm your model’s parts list or the stamp on the original bar before ordering to ensure compatibility.

• 10" guide bar length matching compact pole saw heads
• 1/4" low-profile pitch common to consumer Greenworks chains
• .050" chain gauge for correct sprocket engagement
• 58 drive links to match drive sprocket and nose configuration

How do I install and tension the new bar and chain?

Installation follows standard pole saw procedures: remove the old bar and chain, fit the new bar into the nose and mount points, place the chain over the drive sprocket, and set initial tension. After a short test cut, recheck and adjust tension to avoid over-tightening or slack that could derail the chain.

• Securely disconnect power or remove battery before servicing
• Align chain teeth in correct cutting direction around the bar
• Use the saw’s tensioning screw for initial snug fit (no binding)
• Run briefly, then retension to account for stretch-in

What cutting performance should I expect from this 1/4" pitch chain?

The 1/4" low-profile chain paired with a 10" bar is tailored for light pruning and limb work, offering smoother cuts with lower kickback risk compared with heavier consumer chains. It’s optimized for maneuverability from a pole saw head rather than heavy felling or mill work.

• Smoother, controlled pruning on branches and small limbs
• Less vibration and lighter load on the motor for cordless units
• Better compatibility with compact sprockets on pole saw heads
• Not intended for thick hardwoods or large-diameter logs

Why choose a genuine Greenworks replacement instead of a third-party part?

Genuine Greenworks parts are built to the brand’s tolerances, helping ensure correct fit, chain-bar geometry, and safe interaction with the pole saw’s drive components. An OEM combo reduces the risk of premature wear, poor tensioning fit, and compatibility surprises that can arise from non-branded items.

• Manufactured to Greenworks specification for reliable fit
• Consistent material and heat treatment for expected durability
• Reduces chances of mismatched drive link counts or gauge errors
• Backed by the Greenworks parts ecosystem for support

Who this is for: This 10" bar and chain combo suits homeowners and landscapers who need a direct-fit replacement for compact Greenworks pole saws used for routine pruning, trimming, and light branch removal. Choose this set if you want an OEM-quality swap that restores balance and cutting behavior without modifying your tool.