Frienda Polytape Corner Insulators 10 pcs — for up to 45 mm tape with 304 stainless screws

Frienda 10 Pcs polytape corner insulators are screw-in connectors that secure electric fence tape to wooden posts for corners, ends, and inline attachments.

These connectors combine impact-resistant plastic buckles with 304 stainless-steel screws to hold polytape up to 45 mm (1.7 in) wide. Sold in a 10-piece pack, the set is sized for standard wooden posts and built to reduce tape movement and minimize shorts where tape meets a wood surface. The parts are designed for quick hand or power-screw installation and suit a range of fencing layouts from single-line perimeter fences to multi-corner paddocks.

How do these connectors keep polytape from slipping or shorting?

The buckle and screw system grips the tape while keeping it insulated from the wood post. The plastic buckle seats the tape and holds it in place; the stainless steel screw secures the assembly to the post without conducting between tape and wood. That separation helps lower the chance of accidental contact or wear that can cause weak points in the circuit.

• Holds polytape up to 45 mm (1.7 in) wide
• Plastic buckle isolates tape from the wood post
• 304 stainless steel screw resists corrosion and maintains clamping force
• Design limits lateral tape movement to prevent abrasion

What sizes and materials are included, and will they fit my posts?

Each connector assembly measures about 5 inches (12.7 cm) in overall length with a screw diameter around 0.38 inches (0.96 cm). The buckle accepts tapes up to 45 mm wide. These parts were made for common wooden fence posts; the screw thread profile and length are suitable for standard timber but do not include additional masonry anchors for nonwood substrates.

• Pack of 10 insulators with screws and buckles
• Overall length ≈ 12.7 cm; screw diameter ≈ 0.96 cm
• Accepts tape widths up to 4.5 cm (45 mm)
• Best suited for wood posts; requires separate anchors for concrete or metal

How simple is installation and what tools or parts are needed?

Installation is straightforward: pre-drill or pilot the hole in the wooden post, screw the stainless fastener through the insulator, then thread the polytape into the buckle. You can complete this by hand or with a power screwdriver. Screws or nails to hold the insulator body are not included, so have basic fasteners and a screwdriver or drill ready.

• Hand or power screwdriver for the stainless screw
• Optional pilot drill bit for harder timbers
• Tape threaded into buckle—no special clips required
• Does not include nails, screws for initial body mounting

Where on a fence should these be used and can they work with gate handles?

Use these connectors at corners, ends, start points, and for inline splices where tape changes direction or ties off. They work well wherever you need to secure tape to wood while maintaining electrical isolation. The buckles can be used near gate handles for a tidy, stable tape anchor, though gate hardware should be checked for compatibility first.

• Corner and end anchor points for continuous tape runs
• Start/finish posts and splice points between sections
• Compatible with many gate handle setups for tidy routing
• Mix-and-match with other insulators for complex layouts

Who is this for? Frienda’s 10-pack polytape corner insulators are aimed at farmers, horse and livestock owners, contractors, and DIYers installing or maintaining wooden-post electric fences. If you need corrosion-resistant fasteners, an easy-to-fit buckle for wide polytape, and enough pieces for a multi-corner job, this kit gives practical, durable hardware for routine fencing tasks.