FibroPool Pool Filter Hose Kit — 2-Pack 1.25 in x 6 ft PTFE with adapters & stainless clamps

FibroPool Pool Filter Hose Kit is a complete two-hose replacement set (1.25 in x 6 ft) that includes adapters, clamps, and PTFE tape to quickly restore a leak-resistant pump-to-filter connection. Replacing a tired or damaged filter hose doesn't require hunting for parts — this all-in-one kit bundles two flexible 6-foot hoses, matching adapters, stainless clamps, and sealing tape so you can finish the job in minutes. The hoses are sized for most 1.25-inch above-ground pool plumbing and built to bend without collapsing, helping maintain steady circulation and reliable backwash performance.

How does this kit simplify replacing a worn pool filter hose?

The kit groups every part you need in one package so you avoid mismatched fittings or extra trips to the hardware store. Follow a few simple steps with common hand tools to swap the old lines for new ones and get the pump and filter flowing properly again.

• Includes two 6 ft hoses pre-cut to 1.25 in diameter for common pool hookups
• Provides two adapters keyed to standard pump and filter ports
• Comes with clamps and PTFE tape to create tight, leak-resistant seals
• Installs with a Phillips screwdriver and pliers — no specialty tools required

What materials and design features keep water flow steady?

The hoses are made with a flexible, kink-resistant construction that supports consistent circulation during normal operation and backwash cycles. Adapters and metal clamps add mechanical strength at connection points while PTFE tape seals threads to reduce seepage.

• Flexible hose body resists pinching and kinking under bends
• Adapters ensure correct alignment between pump and filter fittings
• Clamps hold fittings securely even under pressure fluctuations
• PTFE tape helps prevent slow leaks at threaded joints

Will this kit fit my pool system and what configurations does it support?

The hose diameter (1.25 in) is commonly used on many above-ground pool pumps, cartridge filters, and sand systems. The included adapters increase compatibility, but verify your unit's connection size before ordering to ensure a proper match.

• Designed for systems using 1.25-inch plumbing ports
• Works with pumps, sand filters, and cartridge setups with matching fittings
• Adapters provide extra flexibility for slightly different connector types
• Two 6 ft hoses let you route both suction and return lines as needed

How long does installation usually take and what tools are required?

Most installations take 15–30 minutes when replacing like-for-like hoses. The process is straightforward: remove clamps, detach the old hose, press on the new hose with adapters, tighten clamps, and finish by wrapping threaded joints with the supplied PTFE tape.

• Typical install time: 15–30 minutes for an experienced DIYer
• Tools: Phillips screwdriver and slip-joint pliers
• All replacement parts included — no extra purchases necessary
• Clear step sequence reduces risk of leaks and misalignment

Who is this for The FibroPool Pool Filter Hose Kit is aimed at pool owners, maintenance technicians, and seasonal service providers who need a convenient, cost-effective replacement for worn filter hoses on above-ground systems. Choose this kit if your setup uses 1.25-inch connections and you want a ready-made solution that includes adapters, clamps, and sealing tape to ensure a quick, watertight repair without searching for separate components.

FAQ

Q: Does the kit include everything needed to replace both filter hoses?

A: Yes. The kit contains two 6 ft hoses, two adapters, two clamps, and PTFE tape for complete replacement.

Q: Will these hoses fit my above-ground pool pump?

A: They fit most systems requiring 1.25-inch hoses. Verify your pump and filter port sizes before ordering.