Feotech 10AWG Solar Extension Cable Kit 100ft – Twin Wire with 6 Pairs IP67 Waterproof Connectors & Wire Stripper

Feotech Twin Wire 100FT 10AWG solar extension cable kit provides heavy-duty, weatherproof DC connections for panels, RVs, boats and off-grid systems, complete with six male/female IP67 connectors and a wire stripper.

Extend your solar array, run a reliable feed to an MPPT or charge controller, or add remote panels without guessing conductor size. This kit includes a 100-foot run of twin 10AWG (6 mm²) cable, six pairs of threaded IP67 male/female solar connectors for secure outdoor terminations, and a dedicated wire stripper so you can assemble waterproof joins in the field. Materials and construction prioritize conductivity, UV and moisture resistance, and low voltage drop for longer cable runs.

How does this cable reduce voltage drop on longer runs?

Using 10AWG (6 mm²) conductors helps keep resistance low compared with thinner cables, which reduces energy lost as heat and preserves panel output at the controller or inverter. The twin conductor layout simplifies polarity management and parallel/series connections for multiple panels.

• 10AWG / 6 mm² copper-equivalent conductors for lower resistance
• 100-foot length for flexible panel placement without multiple joins
• Twin core simplifies routing and reduces installation errors

Are the connectors truly weatherproof and easy to use outdoors?

The kit supplies six pairs of threaded male and female connectors rated IP67, designed to resist dust ingress and temporary immersion. The screw-lock design and rubber seals create a dependable waterproof connection suitable for marine, automotive and rooftop use.

• IP67-rated threads and seals for dust and water protection
• Threaded coupling prevents accidental disconnects in vibration-prone settings
• Clear polarity marking reduces miswiring during installation

What tools and preparation are needed to install these solar leads?

Feotech includes a wire stripper so you can prepare conductor ends on-site; no special crimping tools are required for the connector housings. Standard hand tools (screwdriver, wrench) and basic electrical tape or heat-shrink for extra sealing are recommended for a tidy installation.

• Included wire stripper for precise insulation removal
• Hand-tighten threaded connectors, then secure with small wrench if needed
• Use heat-shrink or silicone sealant for additional environmental protection

How durable is this cable for marine, RV and rooftop environments?

The outer jacket is formulated to resist UV, moisture and temperature swings typical in outdoor installations, while internal conductors maintain conductivity. Properly routed and secured, the assembly resists abrasion, weathering and vibration common to boats, vehicles and exposed roof runs.

• UV-resistant outer jacket for sun-exposed installations
• Moisture-resistant insulation and IP67 connectors for wet conditions
• Flexible enough for routing through conduits and around corners

Who this is for: Installers, vanlifers, boat owners, RV and tiny-home builders, and DIY solar enthusiasts who need a single, robust solution to extend DC solar wiring up to 100 feet. Choose this kit if you want thicker conductors for lower voltage drop, reliable waterproof connectors for exposed locations, and a compact starter tool (wire stripper) to prepare terminations on the spot. For very long runs beyond 100 feet or systems with very high continuous amperage, consult electrical sizing charts to confirm adequate conductor sizing or consider parallel runs.