EGO Power+ 14-inch Chain Saw Replacement Chain AC1400 for CS1400/CS1401 — 0.043" Gauge, Low-Kickback

The EGO POWER+ AC1400 14-inch chain is the factory replacement chain built specifically for EGO POWER+ CS1400 and CS1401 electric chain saws, featuring a low-kickback profile and 0.043-inch gauge for safe, reliable cutting.

If you own an EGO POWER+ 14" chain saw, fitting the correct replacement chain preserves cutting performance and safety. This AC1400 chain is engineered and tested to match the saw's bar pitch and tension system so you get predictable power transfer, consistent depth of cut, and the right clearances for smooth operation. Genuine EGO parts are manufactured to the same tolerances and materials used in the saw's original configuration, simplifying installation and minimizing adjustment time.

How does this chain improve safety during use?

The AC1400 chain uses a low-kickback cutter profile that reduces the severity of sudden upward bar movement, helping you maintain control during common cutting tasks. While no chain eliminates risk, this design aligns with recognized ASTM/ANSI standards to lower the chance of aggressive kickback events compared with full-profile chains.

• Low-kickback cutter shape compliant with ANSI B175.1 guidance
• Shorter, controlled bite on the wood reduces abrupt reactions
• Consistent tooth geometry for predictable cutting behavior

Will this chain fit my CS1400 or CS1401 saw and what are the specs?

Yes — the AC1400 is specified as the replacement chain for EGO POWER+ 14" chain saw models CS1400 and CS1401. It matches the saw’s bar pitch and tension system so you won’t need aftermarket adaptors or major setup changes.

• Gauge: 0.043 inch for correct bar groove fit
• Pitch: 3/8 inch low profile for the CS1400 series
• Length: cut to fit the 14" bar installed on the CS1400/CS1401

How does this chain affect cutting performance and maintenance?

The AC1400 delivers consistent cutting thanks to matched tooth geometry and proper gauge, which reduces vibration and wear on the bar and sprocket. Routine sharpening and proper lubrication will keep chain tension stable and extend the life of both the chain and the saw.

• Matched tooth angles for even chip removal and smooth feed
• Correct gauge reduces rail wear and slipping on the bar
• Fits factory tensioning for easier maintenance and adjustment

What should I expect during installation?

Installation mirrors the saw’s original setup: remove the side panel, align the chain on the bar and sprocket, then set initial tension before final tightening. Using the factory replacement reduces the need for trial-and-error adjustments and helps you get back to work faster.

• Slide chain onto the bar and mesh with the drive sprocket teeth
• Set loose tension, seat the bar, then incrementally tension the chain
• Check lubrication and run briefly to confirm correct fit

Who is this for: The AC1400 14" replacement chain is made for EGO POWER+ owners who want a direct-fit, manufacturer-specified chain for their CS1400 or CS1401 electric chain saw. It’s a good choice for homeowners and pros doing routine pruning, limb removal, firewood preparation, and light felling where predictable performance and reduced kickback are priorities. Choose this chain if you prefer genuine EGO parts for compatibility, straightforward installation, and consistent cutting behavior.