Demimy Heavy-Duty Sliding Gate Wheel Carrier, 6" Dual Rubber Wheels, 800 lb Capacity, Stem-Mount

Heavy-duty Demimy gate wheel carrier with two 6-inch rubber wheels that supports up to 800 lb and prevents sagging on sliding gates.

This Demimy double-wheel carrier is a rugged replacement or upgrade for metal tube, chain-link, and driveway sliding gates. Built from powder-coated steel with zinc-plated hardware and solid rubber wheels, the assembly spans 10 inches and accepts bottom rails up to 2.15 inches outer diameter. The included U-bolts and stem-mount design let you position and fine-tune the unit so gates roll smoothly over concrete, gravel, or turf without dragging or binding.

How much weight and gate size can this carrier handle?

The Demimy dual-wheel carrier is engineered to support heavier sliding gates—up to approximately 800 pounds—by spreading load across two 6-inch rubber wheels. It fits round bottom rails with an outer diameter up to 2.15 inches, making it compatible with many common metal tube and chain-link gate frames.

• Maximum supported gate weight: ~800 lb
• Wheel diameter: 6 inches (two wheels for better balance)
• Overall carrier length: 10 inches
• Maximum pipe OD compatibility: 2.15 inches

What materials and weather protection does the carrier use?

The carrier pairs a powder-coated steel bracket with zinc-plated fasteners and solid rubber wheels to resist corrosion and wear outdoors. The robust axle and dual-wheel layout reduce stress on the bracket, and the coating plus hardware plating extend service life in wet or salty conditions when compared to bare steel units.

• Bracket: powder-coated steel for rust resistance
• Hardware: zinc-plated U-bolts and hex bolts included
• Wheels: solid rubber for quiet, durable rolling
• Construction: solid axle and reinforced U-shaped buckle design

How simple is installation and adjustment?

Installation is straightforward: the kit ships complete with two M12 U-bolts and four M8 hex bolts with nuts for stem mounting to the gate bottom rail. The design allows incremental height and alignment adjustments so you can level the wheels and eliminate rubbing even on slightly uneven ground.

• Mount type: stem mount with included U-bolts (65mm center)
• Kit contents: 1 carrier, 2 U-bolts, 4 hex bolts, nuts
• Adjustment: height and lateral tuning to align gate travel
• Tools: common wrenches or sockets required for assembly

Will these wheels roll smoothly on different surfaces?

The solid rubber wheels are chosen for consistent, low-noise performance across concrete, gravel, and grass. The twin-wheel arrangement spreads weight and minimizes digging or catching, so gates glide more easily and require less lifting force at the latch.

• Best on: concrete and paved driveways
• Effective on: gravel and packed turf with reduced drag
• Quiet operation: rubber dampens vibration and metal-on-metal noise
• Maintenance: occasional lubrication of axle recommended

Who is this for? The Demimy dual-wheel gate carrier is aimed at homeowners, contractors, and farm operators who need a durable, easy-to-install solution for heavy or sagging sliding gates. It’s a practical choice whether you’re replacing worn wheels on a residential driveway gate, supporting a chain-link entry, or fitting a ranch gate that must traverse uneven ground. If your gate has a round bottom rail up to 2.15 inches OD and needs steadier, quieter rolling under heavy loads, this assembly provides a robust and economical upgrade.