Criditpid Grill Replacement Kit for Char-Broil 463241113/463449914 — Stainless-Steel Burners & Heat Shields

Criditpid replacement kit restores Char-Broil 463241113 and 463449914 four-burner grills with stainless-steel heat shields, burner tubes, crossover tubes and igniters so your grill performs like new.

If your Char-Broil 4-burner grill shows rusted heat tents, damaged burner tubes or unreliable igniters, replacing the worn parts is a cost-effective way to extend its life. This complete Criditpid kit includes every commonly failing component for the Char-Broil 463241113 and 463449914 models, all made from stainless steel to resist corrosion and tolerate regular outdoor use.

What exactly comes in this replacement kit?

The kit bundles the parts most likely to need service after years of grilling: four stainless-steel burner tubes, four heat shields (also called burner covers), three crossover tubes and four igniter electrodes. Each piece has model-specific dimensions so they align with the Char-Broil mounting points and fuel ports.

• 4 stainless-steel burner tubes — 15 15/16" x 1"
• 4 stainless-steel heat shields — 15 1/4" x 3 3/4"
• 3 stainless-steel crossover tubes — 6 3/8" x 3/4"
• 4 igniter electrodes — approximately 35.6" (90.5 cm) in length

How does stainless-steel construction benefit my grill?

Stainless-steel materials reduce the rate of rust and warping compared with cheaper plated or thin metals commonly used in OEM parts. That means steadier heat distribution, fewer flare-ups from crumbling shields, and longer intervals between replacements.

• Corrosion resistance for outdoor exposure
• Improved structural strength under high heat
• More consistent burner alignment and flame control

Will these parts fit my Char-Broil 463241113 or 463449914 grill?

These components were made to match the key dimensions and fittings used on Char-Broil 463241113 and 463449914 models. However, grill variants and aftermarket modifications can differ, so measure your original parts before ordering to confirm fit.

• Compare burner tube length and diameter to your existing tubes
• Check heat shield length and mounting tabs against originals
• Confirm igniter electrode length reaches the electrode socket

How difficult is installation, and what tools do I need?

Replacing burner tubes, shields, crossover tubes and igniters is a moderate DIY job usually completed with basic hand tools. Turn off the gas and disconnect the regulator first; most steps involve removing the grates and old components, sliding new tubes into place, and reconnecting the igniter wiring.

• Tools: screwdriver set, nut driver or socket wrench, work gloves
• Time: typically 30–90 minutes depending on experience
• Safety: always disconnect fuel and test for leaks after installation

Who is this for? This Criditpid replacement kit is ideal for homeowners, renters with repairable Char-Broil 463241113 or 463449914 grills, and anyone who prefers repairing rather than replacing a whole unit. It suits DIYers who want durable stainless-steel upgrades for seasonal cookouts, tailgates, camping with a stationary grill, or backyard gatherings. If you need to refresh burner performance, prevent flare-ups from corroded shields, or replace faulty igniters, this kit provides the essential parts to get your grill reliably back in service.

Important note: Always verify the dimensions and model compatibility with your grill before purchasing. If you encounter any fit or quality issues, contact the seller for assistance—Criditpid stands behind the product.