budrash Front Wheel Replacement for Toro 22" Recycler - 8" Non-Drive Wheels, 2-Pack, 1/2" Bore & 1-3/4" Hub

These are two 8-inch non-drive front wheel assemblies by budrash designed to replace Toro 105-1814 style wheels on 22-inch Recycler walk-behind mowers.

If your Toro walk-behind mower has worn or damaged front wheels, replacing them with correctly sized assemblies restores stable steering and consistent deck height. These budrash wheels match the common 105-1814 / 14424 / 205-284 fitment and offer the same key dimensions—8-inch diameter, 2-inch width, 1/2-inch bore and a 1-3/4-inch hub. They do not include a drive gear sleeve, so they’re intended for mowers that originally used non-drive front wheels.

How do I know these wheels will fit my Toro 22-inch Recycler?

Confirm compatibility by checking your mower model number and comparing wheel measurements to your current parts. This kit lists Toro models commonly using the 105-1814 wheel; double-check hub length, bore diameter and whether your original wheel was non-drive. If your mower used a gear sleeve or drive wheel, these non-drive assemblies are not suitable.

• Compatible with Toro 22" Recycler models such as 20005, 20017, 20031, 20007, 20073, 20018, 20071 and 20041
• Wheel dimensions: 8" diameter × 2" width
• Bore: 1/2"; hub length: 1-3/4"
• Designed as non-drive (no gear sleeve included)

What differences should I expect between these non-drive wheels and drive-style wheels?

Non-drive wheels lack a gear sleeve and are intended for front positions that simply roll and steer, not transmit power. They are typically simpler in construction and easier to install, but they won’t replace wheels that connect to a drive mechanism. Choosing the correct type avoids installation problems and premature wear.

• No internal gear sleeve—meant for free-spinning front wheels
• Simpler installation where axle retains wheel without drive coupling
• Not compatible with mowers that use front-wheel drive gear assemblies

How do I install these replacement front wheels on my mower?

Installation is straightforward for most walk-behind mowers: remove the retaining clip or nut from the front axle, slide off the old wheel, then install the replacement wheel and secure it. Ensure the axle and bore are clean and undamaged before assembly; use light grease if desired to ease fit and reduce corrosion. Tighten retainers to the manufacturer’s specification—do not over-torque.

• Remove existing wheel retaining clip or nut
• Slide off old wheel and inspect axle for wear
• Install budrash wheel onto axle, secure with original retainer

What durability and fit features does this 2-pack include?

Each wheel in this two-pack matches the OEM outer dimensions for reliable deck clearance and steering geometry. The 1/2-inch bore fits standard Toro front axles, while the 1-3/4-inch hub gives adequate support for common front-end mounts. Supplied as a pair, the kit replaces both front sides at once for even wear and consistent handling.

• Sold as a two-wheel set for matched front performance
• OEM-equivalent 8" × 2" sizing for correct ground clearance
• 1/2" bore and 1-3/4" hub length for secure mounting

Who this is for: This 2-pack is aimed at DIY lawn equipment owners and small repair shops who need a cost-effective, reliable replacement for worn front wheels on Toro 22-inch Recycler walk-behind mowers. Choose this set if your mower originally used non-drive front wheels and your measurements match the listed bore, hub and diameter. If your mower uses a drive-style front wheel or different dimensions, check OEM part numbers before ordering to ensure correct fitment.